Follow These Steps Before Using Diamond Saw Blades

By Author: Jason Carter
Total Articles: 61
Comment this article

Do you know which works should be done at first before using diamond saw blade for cutting? If yes, you would be very familiar with the saw blade industry, if you don’t know related tips, don’t worry, this is the exact article for you, follow me to read if you are interested in such topic.

Firstly, you have to clean the saw blade completely, especially the interior parts, so as to make sure that there is no any dirty mark on its surface, and after being installed again, you have to check whether it can be used in good condition. In the next, it is time to pour some lubricating oils into the auto oil lubricator, be careful about the cleaning condition of oil container.

Secondly, check both the water pressure and the wind pressure, as usual, both of them should be in the normal value, otherwise there would be some negative affects when using.

Thirdly, when using hole digger, you should at first make sure that the quality of hole digger should meet the requirements, and if it is the poor quality hole digger, please not to use it because sometimes security incidents would be happened under such circumstance.

Fourthly, ...
... join up the wind pipe and be careful that all the dirty marks in pipe should be cleaned completely, then it is time to join up water pipe, similar with the wind pipe connection, dirty marks should be cleaned. Both the wind pipe and water pipe should be twisted tightly so as to avoid some harm on workers when using saw blade.

Fifth, use shank to insert its hear parts and then rotate drill rod deasil, if it can not be rotated, it is the signal that saw blade inside parts would be got stuck and you have to deal with such condition with right ways in time.

Sixth, twist all the bolts at the connection parts tightly and then turn on the switch to check whether thruster can be used normally, only with the normal condition, you can start to cut with diamond saw blade.

Seventh, if it is the guide rail style, the holder should be used to support the machine body and then you should check the working condition of thruster. As for the hydraulic pressure electroplating annexing agent, under the electric field condition, you can find it from electrode process and it has some effects on the metal electro-crystallization process.

Let me introduce Flostools to you, which is the professional Circular Saw Blades Manufacturer in China. You can get Panel Saw Blades, together with Plastic Cutting Saw Blades at here with affordable price.