Copper Pipe Repair Has Been Revolutionized By The Introduction Of New Innovative Non-intrusive Techniques That Optimize Flow And Prevent Future Leaks

By Author: Nu Flow
Total Articles: 73
Comment this article

The so-called pinhole leak is the most common leak found in copper pipes, caused by corrosion of the pipe from the outside. Nowadays however, with chemical changes in the soil and water, these leaks also occur on the inside of the pipes. Breakdown happens as a result of poor installation, the age of the pipes, soil and water chemistry. Water treatment plants use high volumes of chemicals in filtering processes, which shortens the lifespan of copper pipes. Routine inspections by certified plumbers to ascertain the condition of the pipeline would be seen a preventative measure.
Although these pinhole leaks start as deceptively small problems, a mere drip of water, the problem can intensify if not addressed and over time, can cause immeasurable and permanent damage to a property by water seeping into crevices and walls. This will weaken the mortar and insulation inside walls, and create an ideal breeding ground for mildew and rot and unfortunately if not properly addressed, will become a recurring problem. If walls are weakened because of water leakage, the structures will most probably have to be replaced. The sooner the ...
... damage is detected and repaired, the less harmful it will be to the home and the budget.
Definite signs to confirm the presence of a pinhole copper pipe leak would be a leak without water puddles, visible pipe corrosion, manifesting as green build up on copper pipes, noise of dripping water, water damage like stains and discolouration, decreased water flow and a spike in the water bill.
This problem is concerning for homeowners, occurs nationwide and is an underlying threat to pipeline systems, irrespective of the age of the installation. No preventative plan of action is in place to circumvent this problem. Only after the breakdown occurs, analysis is done on the pipes that failed. The vast number of variables occurring in hydraulic and water quality parameters are incalculable and intricate concerning vulnerability for failure and leaks.
There are a varied number of ways to address the problem of leaking copper pipes. By trying a temporary solution like the use of epoxy putty for a rapid repair, will remain just that, it will stay temporary and will not address a recurring problem. Repiping or replacing the old system with a new line, is costly, disruptive and time consuming and will cause serious invasion, indoors (by cutting into walls and floors) and outdoors (by digging trenches and uprooting landscapes and driveways).
Many patented methods clean the insides of existing damaged pipes and then seals it with an environmentally friendly nontoxic industry approved epoxy coating which forms a barrier on the inside of the pipe, making it stronger and leak resistant. Further corrosion is also prevented. This wonderful alternative method is cleaner, more cost-effective and less intrusive. Pipes are restored without digging and post-operative repairs and restoration and are accessed via existing pipelines, plumbing fixtures and valves. S LEAK REPAIR
Corroded copper pipes are inspected with camera techniques and then thoroughly cleaned by using an array of cleaning techniques. An eco-friendly epoxy saturated lining which is extremely flexible, is pulled into the existing pipeline starting at the existing access point. A rubber bladder or balloon type device is inflated and this will press the epoxy coating against the pipe walls. The epoxy cold cure UV liners cures shortly, the bladder is removed and a new hardened, durable pipe lining is in place. This is a pipe within a pipe. The immediate result is an increased flow, strengthened joints, sealed cracks and crevices, and the elimination of further pollution. The lifespan of the pipeline is increased, and an added bonus is the non-invasiveness of the whole process.
P
These non-invasive methods are suitable for residential properties, commercial properties, HOA, hotel, government facilities, schools and universities. When managed professionally by experienced project managers and highly qualified and experienced staff, these innovative techniques are beneficial to wide variety of beneficiaries.

About Us
NuFlow, the US based innovative industry leader for small diameter pipe restoration and lining, was granted an exclusive license in 2006 by APL to utilize all technologies and patent rights. This made NuFlow the only licensed pipe and rehabilitation company, manufacturing and installing multiple technology for pressurized and non-pressurized systems. The acquisition of APL in 2007 put them way ahead of the pack. Specializing in all pipe repairs, sewer pipe repair, lead pipe replacement, pipe reclining, and internal pipe coating, with minimum disruption, Nuflow is the company of choice, completing the job speedily with well-trained staff, at competitive prices.
For more information, kindly visit https://www.nuflow.com/.