How To Increase The Oil Production Rate Of Screw Oil Press

By Author: Amit
Total Articles: 1
Comment this article

1. The oilseeds enters in the chamber from the kettle through the processed oilseed during the oil press operation. The screw rotates move forward to press the raw material, because the oilseeds is carried out in motion in the squeezing chamber of the screw press, under high pressure conditions in the squeezing chamber, there is great conflict resistance between the oilseeds and the worms(pressing rings), a collision between the oilseeds and the squeeze chamber can occur.

2. Because the original diameter of the worms gradually thickens and the pitch gradually decreases, when the worms is hitting, the forced oilseed of the thread can be pushed forward and the outer surface of the worms. The material also rolls along the press shaft. In this way, each embryonic particle in the press chamber does not move at the same speed and in the same direction, but there is relative motion between the particles. The heat from the clash meets the heat required to operate the oil extraction machine technology, which helps to promote thermal denaturation of proteins in the embryo, damaging the colloids, increasing plasticity, and also ...
... reducing the viscosity of the oil. The oil production rate of the cooking oil machine, so that the oil estimated by the oil is pressed out, and exits the gaps in rows and strips.

The specific operating method is as follows:

Overcome the Heat. sesame seed is usually cooked in a kettle/cooker, and left to heat completely to reach the moisture at optimum level. If a movable furrow is made on the wall of the kettle and a movable iron plate is embedded, when a heat is required, an iron plate is lifted up to seal the furnace mouth; When a heat is required, an iron plate is placed down to seal the air duct and turn on the upper side kettle, control the heat.

Modified worms. 100 types of horizontal shaft oil presses are composed No. 1 to No. 9, and No. 5 is smaller than No. 6, and the old No. 6 can be used to replace No. 6, so that the internal pressure can be increased. The oil part is returned 8–10 cm. Only this one improvement can produce 1-2 kg of oil per 100 kg of sesame seeds.

Press on hot ingredients. Oil molecules are most vivid at high temperatures. Generally, oilseed out of wok have a temperature of 110 ° C, and the oil will be higher when squeezed when heated. Therefore, the amount of fried beans per pot is best controlled at 40–50 kg, so as to squeeze with heat, to ensure that the hot ingredients are squeezed.

The GOYUM SCREW PRESS is to deliver turnkey oil mill projects within the field of oil processing machinery.