Secret Tips To Remove Carpet Stains

By Author: David Haloossim
Total Articles: 4762
Comment this article

When it comes to removing stains from carpets, first and foremost, do it quickly! Many carpets are coated with a stain-resistant treatment which can often allow you to clean a spill with no problem, provided you get to it right away. But, depending on what caused the stain and the delay between the spill and clean-up, it might not always be that simple. In most cases, the longer you wait to clean the carpet stain, the more difficulty you'll encounter while removing it. Fortunately, there are a few time-tested techniques that you can still turn to when faced with a stubborn carpet stain.

Technically, a "stain" is actually a mark that cannot be removed from a carpet, while a "spot" is a mark that can be cleaned. However, even if you've encountered a permanent stain, there are still ways to effectively reduce the mark's appearance. Let's take a look at how to deal with each kind of mark.

Liquids

If you've spilled a liquid on a carpet, the most important thing to remember is to blot, blot, blot! Using a clean cloth or paper towel, gently blot the liquid, soaking it up from the carpet. Never rub the mark as that ...
... will only push the liquid into the carpet fibers, creating a more difficult stain. Blot the area, and after blotting the excess liquid, clean the area with water and then blot again. Repeat the process until the area is cleared but never resort to scrubbing; if you do, you run the risk of creating a larger stain or, even worse, damaging the carpet.

Semi-Solids

But what if you've spilled a semi-solid, such as peanut butter or oatmeal? In this case, your first course of action is to scrape the marred area with a spoon, gently lifting all the excess material away from the carpet. Once you've removed as much of the substance as you can this way, rinse the area with water and then proceed to blot, rinse, and repeat in the same way you would clean up a liquid spill.

Ink

Okay, so we've covered the basics but what about when it comes to dealing with tougher stains? Ink stains are a pain to remove from just about anywhere and carpet ink stains are especially rough. Fortunately, there is a secret weapon-rubbing alcohol. Apply some rubbing alcohol to a cloth (never pour it directly onto the carpet) and dab the ink stain. Like with other stains, refrain from scrubbing as this will most likely spread the stain. Continue to dab the area until all of the ink is covered with rubbing alcohol, and then let everything sit for a few minutes. Finally, use a vacuum on the area and it should start to suck the ink right out of the carpet. If you don't remove all of the ink the first time, repeat the process. If you don't have access to a vacuum, wait several minutes after dabbing the stain with alcohol and blot the area with a dry cloth.

However, once you've successfully removed the stain, you still have a little bit of work left to do. Any time that you use a solvent such as rubbing alcohol to treat a carpet stain, always be sure to then rinse the area with water upon conclusion. You can then use a wet/dry vacuum to soak up the water or you can use the simple blotting method. Whatever way you choose, it's very important when dealing with ink stains to always dry the area quickly. Even if you've seemingly removed all of the ink stain, there could still be ink remaining deep down in some of the carpet fibers. Failure to quickly dry the area could allow this ink to spread to the carpet's surface due to the moisture in the area, resulting in a reappearing ink stain. So after you've vacuumed or blotted out the last of the water, it's still a good idea to leave a fan blowing over the area for a while.

Blood

Hopefully, you'll never have to deal with removing blood stains from a carpet but home accidents happen and blood is notoriously difficult to get out. Like with other stains, fast action can help you clean up a bloodstain before it penetrates your carpet's stain-resistance. However, if you don't get to it quickly enough, blood can make a very nasty stain.

First of all, treat the area with cold water. That's very important, as hot water can easily have a detrimental effect. Hot water can actually cause a blood stain to become set more deeply into the carpet's fibers, resulting in a permanent mark. Be sure to apply only a minimal amount of cold water at first in order to avoid spreading the stain. From this point, use the same blotting or vacuuming cleanup method mentioned above for ink.

However, this might not always work, depending on the stain. If you still can't remove the stain simply by using cold water, try adding some dish soap to the stain, still treating it with cold water. Again, be sure to gently dab the stain, as scrubbing can damage the fibers which causes the carpet to retain the stain.

Just like with ink stains, be sure to adequately dry the carpet after cleaning. Blood can also "reappear" on a carpet if the stained area retains any moisture.

Hopefully, these tips can help you deal with frustrating stains. But always remember the best tip for cleaning a carpet-the faster you get to a stain, the better your chance of getting it out.
About Author:
Browse Contempo Floor Coverings.com to learn about Hardwood Flooring and green flooring products for residential, commercial, or retail flooring. Natural cork flooring, hardwood flooring and Los Angeles marmoleum flooring are popular green flooring products. When it comes to Los Angeles Flooring products, our marmoleum is the best. Visit online today.